Replacing the Icp Sensor in Your 2004 to 2010 6.0 Powerstroke

This repair is relatively easy and will save you hundreds of dollars, and is well worth the effort. This article will cover how to remove the sensor, its location, and repair options. You'll be able to complete the job in a day's work! Read on for some tips! Before you begin, be sure to know the location of the ICP sensor in your 6.0 Powerstroke visit here prosourcediesel.com

ICP sensor failure rate

The ICP sensor is an essential component of the 6.0L Powerstroke. However, if you don't know how to replace it, the result could be serious damage to your vehicle. Before you can perform this repair yourself, you must know more about the ICP sensor. This article will provide you with the information you need to ensure a proper ICP sensor replacement. We recommend you start by learning how to identify and diagnose ICP sensor failure in your Powerstroke.

Location

Your 7.3L Powerstroke is equipped with an ICP sensor. You can access it through the HPOP cover on the passenger side of your engine. The earlier versions were mounted near the turbocharger and up-pipes, which creates tremendous heat and degrades the connector. However, a 2004 to 2010 Powerstroke does not feature an up-pipe collector. In either case, it should not be difficult to locate the ICP sensor.

Repair options

If your 6.0 Powerstroke is suffering from troublesome ICP leaks, you might want to consider replacing the ICP sensor. A bad ICP sensor can result in problems such as no start or rough running, reduced revs, and even a cutout or engine shut-down. In addition, aftermarket cps sensors can also be defective out of the box. Repair options for replacing the ICP sensor in your 2004 to 2010 Powerstroke are extensive, so a professional is highly recommended.

Cost

Replacing the ICP sensor is one of the more common repairs for your diesel engine. The ICP sensor is located in the 7.3L Powerstroke engine. It may appear different on your 1999-2003 model than the 1994.5-to-97 generation, but it is actually the same sensor. If the ICP sensor on your truck is not working properly, it will not start and will have to be replaced.

Installation

The ICP sensor is a part located in 7.3L Power Stroke diesel engines. These engines may look different from the 1994.5 to 1997 model year engines, but the replacement procedure is essentially the same. Install the new sensor by removing the old one. Make sure to use proper torque when installing the new one. Ensure the o-ring is clean and greased before installing the new part.