Samsung Galaxy Phone Parts

Then just set down the screen and generally, you want to put the clamps on now but in my situation, I put the back piece on, and then I'm going to put the clamps on I recommend five clamps on the right side five clamps on the left and one on the top and the bottom after we let that sit for about an hour to two hours we can remove the clamps but I've only let it sit for a few minutes so I'm going to remove the adhesive on the back panel which is something that you can do while you let the glue dry now that everything's dried we can remove the clamps and we can start putting in these screws like this there's no specific order that they go in but just definitely make sure to keep them in order and now we're going to grab some new adhesive and we're gonna put it around the edges like this if you plan on opening this samsung phone parts up again be careful around the antennas on the top and the bottom but in my situation, i don't plan on opening this phone up again and if you have some extra adhesive.

You can apply it to this little area right here and under the camera then all you got to do is just set the back on in place and make sure to put in that sim card tray and everything is good I hope this video helped you out if you have any questions leave them in the comment section or message me on Twitter i get bored over there subscribe to my channel so you can see more videos like this as well as some review videos and hit that bell button so then youtube reminds you when those videos do come out thanks for watching. In GSM Communication Samsung A920F we will change the display back cover. The device is in the upper right corner broken screen. The back cover is broken. Now together we will change the screen and back cover. For easy removal of the back cover of our heat gun 200 degrees with the condition of being in the heat setting heating Samsung phone parts.  We will ensure that the adhesive is removed more comfortably. The screws removed in the device are very important. Which screw is removed from where screw sizes It is very important that the screw removed is placed in the same place. be careful about this. Middle case. The lath of the device. First of all, we disconnect the current. Before starting work.

Network antennas of the device. Buzzer piece. Sub speaker. Our piece we call buzzer. Charging board of the device. At the same time, network antennas, samsung phone parts . On this piece. Headphone. The 3.5mm jack input is also here. Intermediate flexes. Here is the image flex. Blah. The most important part of the device. Motherboard. Spray that we squeezed so that the battery can be easily removed from here adhesives under the battery for easy dismantling Between battery and adhesive a blooming spray. Any way to the device it is not a damaging spray. Vibration motor. Internal headphones. The part we call the handset. Sensor. And the broken screen of the device. Along with the new screen, the inner headset is already included. That's why we won't even wear it. Keep a new piece. Where are you removing which screw pay attention to it. Now look, the black screws are short. Instead there if you attach it from other gray screws either damages the device or damage the screen from below. For this, which screw is removed from where it is very important to put it back in the same place.